Level Jacks

ScaffoldMart.com's Scaffolding Level Jack


We offer our scaffolding level jacks in two sizes, a 1.375" OD level jack (#6 tube) or a 1.25" OD level jack (#5 tube). If you know what you need, ou can select your desired quantity from the table below and click "Add to cart." For more specific technical information on a product, click it's name in the table to visit it's product page, where you can also add to cart with a similar table.


Our level jack is a solid-steel 24" threaded rod welded to base plate at a right angle. Allows for individual adjustment of each leg in a stationary position on relatively level surfaces. Here's what makes our scaffolding level jacks the best:

  • Solid-steel rod, not hollow.
  • Wing-nut is a massive 9.5" long, this gives increased leverage and ease of adjustment under load.
  • Precise square acme threads allow for increased ease of adjustment under load.
  • Cold-dip zinc galvanized for increased weather resistance.

Quantity Pricing (1.375 OD)

1-8        $15.50

9-49      $14.60 

50-249  $10.00

250+     $9.25

Large order/distributor/reseller inquire. We are unbeatable!


Items: 19 of 9, per page

Jacks are necessary outside or anytime you have uneven ground. A level jack is a large threaded rod with a wing nut and a welded steel plate called a base plate on the bottom. Level jacks are a must for a safe, stable, level work platform. Our jack is 24 inches in height which allows an adjustable range of 18 total inches.

This allows you to locate a platform where it might otherwise be impossible. At six inches height, load rating is 13,013 pounds with a 4-to-1 safety margin. At 18 inches the safe load rating is 8,838 pounds with a 4-to-1 safety margin. See our scaffolding load test results here.

Scaffoldmart carries only a solid-steel scaffold jack, not a hollow jack like some other compa
nies. Our wing nut is huge. It’s almost 9.5 inches in length. The longer the nut the easier it is to adjust it under load. We use precision square top acme threads so you can spin the nut and it spins for several seconds which shows the precision mating we have achieved with our jack. This is how we define quality. Finally it’s hard to have a precision thread and hot dip it because the thickness of the zinc interferes with the precision thread. But we do cold zinc our jacks.

If you need to work on unleveled ground or an unleveled rooftop consider Scaffoldmart's swivel jacks. They are very handy for working around a chimney on the roof. They are 24 inches in total length. The actual adjustment range is 18 inches of upward adjustment.

Grady Smith

CEO, ScaffoldMart.com